If you work on pistol red dot stuff you need these bits! Optic bodies make it hard for the shorter bits to engage the screw properly which can lead to damaged or stripped screws. Be a pro and use the best bits!
I get my bits from KC Tool:
https://bit.ly/3O1y1Mr
Wera 50mm Power Bits
Standard 5/64, 3/32, 7/64, 1/8, 9/64
Metric 2, 2.5 and 3mm
Torx T8, T10, T15, T20
Check out the article on our website with direct links to all of the above bits, my favorite handles and supplies.
https://www.gunsandtactics.com/best-bits-for-working-with-handgun-rds
Got questions about firearms setup, anything else or a quick tip suggestion, send us an email:
theqa@gunsandtactic.com
0:00 The Tease
0:08 Intro
0:28 The Bits
0:58 The Good Bits
1:44 Final Thoughts
Be sure to check out our website for more.
https://www.gunsandtactics.com
Social Links:
- Instagram:
https://bit.ly/3oelbin
- Facebook:
https://bit.ly/2T9lP2c
- Twitter:
https://bit.ly/34bAMXE
- Patreon:
https://www.patreon.com/gunsandtactics
- Note for YouTube: The portions of this video featuring the firing of a firearm were conducted at a specified range facility in a controlled, safe environment under the direction of instructors or range safety officers.
- The views and opinions expressed in this video are solely those of the original authors and contributors. These views and opinions do not necessarily represent those of Guns & Tactics, the administrative staff, and/or any/all contributors to this site.
- Affiliate Disclaimer: Guns and Tactics is reader/viewer supported. This post may contain affiliate links and we may earn a small commission when you click on the links at no additional cost to you. As an Amazon Affiliate I earn from qualifying purchases.